Support Questions

Ask a Question

There are no questions. Be the first to ask a question!

FleXD is a TPU with hardness Shore 93A. It's bouncy yet firm, suitable for all kinds of fun applications as well as for printing gaskets, tyres, seals, and ice trays. Spool weight: 500g

  • Print Temperature: 215 - 225°C
  • Bed Temperature: 40 - 80°C
  • Bed Adhesion: Glue stick on glass, no additional adhesive needed on PEI sheeting or blue tape.
  • Part cooling fan: Medium to high speed
  • You will want to print FlexD a lot slower than stiffer filaments, you should start with a print speed of 15mm/s, you may be able to increase this value to around 25mm/s if you are printing hot enough.
  • You will also want to have the retraction turned off, once you start having good extrusion results you may be able to introduce a small amount of retraction to clean up the surface quality but do so with caution, and only use minimal amounts.
PropertyValueUnits
Ultimate tensile strength:42Mpa
100% modulus:9.8Mpa
300% modulus:20Mpa
Elongation at break:500%
Hardness (Shore A)93AShore A
TypePart #SupplierURL
spoolWorks FleXD Filament - 'Very' Black20F-SW-FLEXD-BLACKE3Dhttps://e3d-online.com/spoolworks-flexd-...
spoolWorks FleXD Filament - 'Bright' WhiteF-SW-FLEXD-WHITEE3Dhttps://e3d-online.com/spoolworks-flexd-...
spoolWorks FleXD Filament - 'Crystal' Clear01F-SW-FLEXD-CLEARE3Dhttps://e3d-online.com/spoolworks-flexd-...
spoolWorks FleXD Filament - 'Rose' Red05F-SW-FLEXD-REDE3Dhttps://e3d-online.com/spoolworks-flexd-...
spoolWorks FleXD Filament - 'Sweet' OrangeF-SW-FLEXD-ORANGEE3Dhttps://e3d-online.com/spoolworks-flexd-...
spoolWorks FleXD Filament - 'Monster' Green16F-SW-FLEXD-GREENE3Dhttps://e3d-online.com/spoolworks-flexd-...
spoolWorks FleXD Filament - 'Oxford' Blue22F-SW-FLEXD-BLUEE3Dhttps://e3d-online.com/spoolworks-flexd-...
View Statistics:

Past 24 Hours: 2

Past 7 Days: 8

Past 30 Days: 37

All Time: 559