Ryan Smith

Hi Jack The standard E3D V6 12V fan airflow is 4.5cfm

Hi, you should find that the windings in the motor are good up to 80 before they will start to fail.

It's under a GPL3 license which is truly open-source - read all about what that entails here.

You can just configure your settings as 2 x V6 hotends - what settings are you trying to fix in particular?

1 It's not going to create much of an issue, just a temperature offset... 2 - most host software gives you an option to insert the temperature offset rather than digging into firmware settings.

Try bringing your retraction down to 1-2mm - it's not a bowden system any more and you may have left the settings as previous?

Unfortunately unlike standard hotends the Cyclops can't be cleared via a cold pull or other standard cleaning procedures - we'd suggest running some cleaning filament through it. We really recommend matching filament types in Cyclops and not mizing from, say, PLA to ABS, or PET-G to a support material. Chimera is ideally suited for that type of dual extrusion.

It sounds like the motor current needs adjusting - do you know what it's currently set at?

You need to allow for 0.83 Amps for the pump and 0.2 for the fan

All of those surface types will work for Scaffold support filament - our personal preference here is a light touch of gluestick onto the glass bed.