Thanks again, great instructions and my Hemera is alive and printing! I wanted to mention:
1) IMPORTANT: I interpreted your wiring diagram to mean that the X-max switch should have jumper, i.e. bridge pins 11-12. This needs to be left open.
2) Don’t tighten the mounting screws for the blower too much. My blower wouldn’t turn until I loosened these to just snug.
3) FWIW, the Hemera I got from Filastruder had the extruder, gears, and motor fully assembled. However I needed to mount the heatbrake, nozzle, heater, and so-forth. I’d consider removing steps 1-15 and just have links to the Hemera assembly documentation.
I appreciate the effort put into writing this guide—it was a great help!
Thanks again, great instructions and my Hemera is alive and printing! I wanted to mention:
1) IMPORTANT: I interpreted your wiring diagram to mean that the X-max switch should have jumper, i.e. bridge pins 11-12. This needs to be left open.
2) Don’t tighten the mounting screws for the blower too much. My blower wouldn’t turn until I loosened these to just snug.
3) FWIW, the Hemera I got from Filastruder had the extruder, gears, and motor fully assembled. However I needed to mount the heatbrake, nozzle, heater, and so-forth. I’d consider removing steps 1-15 and just have links to the Hemera assembly documentation.
I appreciate the effort put into writing this guide—it was a great help!
Thanks for the excellent guide! One question: are there links to the printed part (mounts) STLs somewhere? Apologies if I just missed them.