Help
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.
This calibration file has been pre-sliced using settings for the Titan/Bowden setups. As such it could be a problem printing it using other setups. Is there an unsliced stl available???
The verification and modification as needed of the dock locations in the tFree and tPre files should be added.
Scattering the instructions for the ht hbp across multiple guides is not a good idea. It should all be one place both bed install as well as wiring.
Something should have been said about WHICH BOARD the E0 and E1 connections are going on to.
These seem to go to the Duet board while E2 and E3 go to the extender board. RIGHT?????
NO. The fan cable is way too short to through the aluminum part
No thread lock?
Don’t forget to insert the filament guide under the top collet that holds the guide tube.
i used the smaller Allen wrenches to align the holes while tightening this first bolt. It makes putting in the longer bolts much easier.
Seen this kind of poorly thought out approach to blind mounting PSs before. The very first time the PSU gets replaced Ill use a secondary bracket to make remove/ replace less then painful.
This part of the build was brilliant.
Page 1 of 2
Next