This incorrectly says “M3 washer” but the picture is correct showing the M3 nut.
Later in the guide (step 29) you talk about making sure the faces are flush. It would probably be better to make sure it’s aligned and tested at this step so folks don’t have to take it apart again.
Great guide! Just followed it last night to assemble my new kit.
One suggestion, it’s much easier to connect the thermistor and heater cartridge at the end. This way as you’re handling the unit the wires aren’t constantly in your way. I did it in the guide’s order and after having to take it apart to fix the grab gear alignment, I just removed them until the end and it was a little easier.
It would be helpful to call out here that one of the M3x30 screws has the blue tip. This way somebody doesn’t accidentally use it in one of the other holes.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.