Questions
-
PT100 Amp Board with Ultimaker 1.5.7 pcb wiringAttempting to wire this up, it’s not working as I’ve got it (into the temp sensor 1 slot). Can someone please just tell me ho...
-
V6 Thermistor Table for Repetier Firmware UpdateI’ve been trying to get my V6 working properly with my Boxzy printhead for about 2 weeks now and finally figured out (I hope)...
Answers
-
Answer to: V6 Thermistor Table for Repetier Firmware UpdateWell, I've already taken care of it and got it up and running. And then two days later the amplifier board for the PT100 I got from you guys showed up so I installed that and my printer isn't running again. Followed y'all's instructions to the T, continuity tests out fine on the wiring, firmware verifies and uploads and then I open the GUI (Repetier type)and this is what I get in the log before I even connect to the printer - 16:05:30.169 : ImportPlugin:Could not load file or assembly 'CncPlugin, Version=1.0.0.0, Culture=neutral, PublicKeyToken=null' or one of its dependencies. Operation is not supported. (Exception from HRESULT: 0x80131515) 16:05:30.172 : at System.Reflection.RuntimeAssembly._nLoad(AssemblyName fileName, String codeBase, Evidence assemblySecurity, RuntimeAssembly locationHint, StackCrawlMark& stackMark, IntPtr pPrivHostBinder, Boolean throwOnFileNotFound, Boolean forIntrospection, Boolean suppressSecurityChecks) 16:05:30.172 : at System.Reflection.RuntimeAssembly.InternalLoadAssemblyName(Ass...
-
Answer to: V6 Thermistor Table for Repetier Firmware Updatewow, great support here, jolly good
Guide Comments
Active Hours
The time of day that you have been active over the last 90 days. Each line on this graph is an action you performed on the site (we only count major actions, like voting and editing posts). The numbers on the bottom of the graph are the hour of the day in Mountain Standard Time.
Reputation over time
Reputation Breakdown
Event | Count | Delta |
---|---|---|
Accepted answer | 2 | 20 |
510
Recent Notifications
Mark all as read
Show:
All
All
Unread
Hi, I’m re-updating my firmware after installing the v6 as it didn’t seem to be getting up to the temperature requested in my g-codes. I noticed that the user_thermistortable in the pic above is set at 2 whereas my original printer firmware has it set at 0. Could this be the source of my issue?