Please add this type of note to Step 14.
If the Titan Lid does not fit flush, The Pinion Gear might be hindering it to be flush. Loosen the grub screw and adjust the positioning of the pinion gear on the motor's shaft. You may need to unscrew the extruder body to get at the grub screw.
Step 19 says….
Insert the PTFE tubing. The collet clip should pre-tension the tubing and lock it into the hotend; the tubing should be held securely downwards without any ability to wiggle or move.
How far in “mm” should the PTFE tube be inserted? When I fed in the PTFE tube it went just past the black collet and I did not want to force it any further by hand. If I removed the blue clip, I was able to insert the PTFE to the stop in the heat break. Then I reseated the blue clip. Clarification on the instructions is required.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.