Insert the heater cartridge into the top of the heater block.
You may have to gently bend the wires 90° in order for the heater block to fit underneath the heat sink.
Although the wire is thicker than our other heater cartridges you will still need to be careful not to snap it. Ideally you should aim to avoid a sharp radius on the bend.
Fasten the two M3 grub screws into the Heater block to clamp down on the heater cartridge.
Make sure the heater cartridge doesn't move when you tug at the wires gently.
You should also avoid fatiguing the wire, ie once you have bent it don't move the wire again.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.