Skip to main content
Help
Editing Step 34 —

Step Type:

Drag to rearrange

You're now ready to go! Remember you'll have to update your slicer settings a little:

Check your nozzle diameter in your slicer. All V6 kits ship with a 0.40mm brass nozzle.

Having very long retraction settings will cause problems.

For direct extrusion systems you should use anywhere from 0.5mm–2mm of retraction.

For bowden systems you need to use the same as with direct + the compression strain, which will depend on the length of your Bowden tube.

Print PLAs at 205–215°C, and ABS at ~240°C. For other materials check with their manufacturer