Skip to main content
Help
Editing Step 24 —

Step Type:

Drag to rearrange

Plug the extension wires into your thermistor and fan. The other ends will go into your printer's electronics board.

If you're replacing an old HotEnd, note where its wires were plugged in and mirror those for your new V6.

If you're building a new printer, you may need to consult the documentation for your electronics board to see where to plug in everything.

Use the included cable tie to link the connections together for strain relief.

Take a little while to properly organise your wiring so that it doesn't get snagged on any corner of your printer.