The whole X-Carriage can now be offered up to the parallel rails.
Locate the LM8UU bearings into the bearing slots on the rear of the carriage.
Thread the 2.5mm cable ties though the small slot, they should re-appear on the opposite side of the bearings.
Secure the cable ties tight to hold the X-Carriage in place.
Release the X-Belt tension pulley then loop the belts around the teardrop anchors and back on themselves so that the belt teeth lock against each other.
Slide the belt loops all the way into their respective slots on the back of the X-Carriage.
Try to get this as tight as you can, then use the X-Belt tension pulley to achieve final tension required. You may want to refer to the documentation that came with your machine for this step.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.