Skip to main content
Help
Editing Step 29 —

Step Type:

Drag to rearrange

Place x1 M3 square nut in the bottom right T-slot.

Place the printed part cooling duct on the front side.

Fasten the fan duct using x2 M3 x 6mm screws.

Be aware it is possible to crack the t slots if you use screws that are too long and bottoms out. Our recommendation is to use screws that protrude 3mm +- 0.25mm from the mounting surface to go into the T-Slots. Over tightening also risks snapping the T slot.