Next, mount the fan adapter plate onto the front side of the Hemera.
Use two more square nuts and shorter M3x5 screws.
Then use the original fan screws and mount the fan to the adapter plate. You may need to push a bit to get the thread started.
Be aware it is possible to crack the t slots if you use screws that are too long and bottoms out. Our recommendation is to use screws that protrude 3mm +- 0.25mm from the mounting surface to go into the T-Slots. Over tightening also risks snapping the T slot.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.