To rotate it, grab the heater block with a wrench and slightly unscrew the heatbreak from the extruder body.
Then unscrew the nozzle half a turn, making sure you don’t put any bending stress on the heatbreak.
Then rotate the block and tighten up the nozzle against the heatbreak by holding on to the heater block and screwing down the nozzle.
and finally lightly tighten the heatbreak back into the extruder body. Now we’re ready to start mounting the Hemera to the printer.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.