Add 4 M3x10 flat head cap screws into countersunk holes
Fit fan into place. The duct is fairly tight, I found it was easiest to tilt the fan up and slip it in as I fit it to the mounting holes
Add two M3x20 socket head cap screws to mount the fan in place.
Be aware it is possible to crack the t slots if you use screws that are too long and bottoms out. Our recommendation is to use screws that protrude 3mm +- 0.25mm from the mounting surface to go into the T-Slots. Over tightening also risks snapping the T slot.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.