Gather your Hermes Mount
Insert 2 T-nuts into the back two slots. If you are looking at the back of the motor insert them into the slots on the right
Pro-tip - cover the t-slots with a piece of tape after the nuts are inserted so they can't fall out during assembly
Add 4 M3x12mm socket head cap screws in the four holes in the back of the Hermes mount
Align Hermes to the bolts and screw them in using a 2.5mm allen key.
Be aware it is possible to crack the t slots if you use screws that are too long and bottoms out. Our recommendation is to use screws that protrude 3mm +- 0.25mm from the mounting surface to go into the T-Slots. Over tightening also risks snapping the T slot.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.