Skip to main content
Help
Editing Step 7 —

Step Type:

Drag to rearrange

Add 2 t-nuts to the t-nut slots on the front of the motor. Add tape to hold them while working

Carefully fit fan duct into place. Make sure it doesn't crush heater cartridge wires and everything is routed nicely

Be aware it is possible to crack the t slots if you use screws that are too long and bottoms out. Our recommendation is to use screws that protrude 3mm +- 0.25mm from the mounting surface to go into the T-Slots. Over tightening also risks snapping the T slot.