Skip to main content
Help
Editing Step 25 —

Step Type:

Drag to rearrange

Insert an M3 square nut in the bottom right hand slot on the front of the Hermes

Secure the blower fan by using the same two screws that it was mounted with before

Plug in the extruder cable provided in the Hermes kit with the white connector side going into the stepper motor

Be aware it is possible to crack the t slots if you use screws that are too long and bottoms out. Our recommendation is to use screws that protrude 3mm +- 0.25mm from the mounting surface to go into the T-Slots. Over tightening also risks snapping the T slot.