Skip to main content
Editing Step 19 —

Step Type:

Drag to rearrange

Using x4 M3 x 4mm screws

Fasten the Hermes to Part B of the mount into the x4 M3 square nuts.

For neater cable management have the thermistor and heater cartridge exiting behind the heater block, when you are facing Hermes.

Pictured here are shortened wire lengths for quick removal, you do not need to do the same.

Be aware it is possible to crack the t slots if you use screws that are too long and bottoms out. Our recommendation is to use screws that protrude 3mm +- 0.25mm from the mounting surface to go into the T-Slots. Over tightening also risks snapping the T slot.