-
-
First things first: you're going to need a copy of RepRap Firmware.
-
Either download a fresh version from GitHub, or edit your existing one.
-
You can edit your existing firmware either through the online configuration tool, or through G-Code.
-
-
-
Manual Editing:
-
For firmware versions 1.16 and earlier, use the following G-Code command in the config.g file on the SD card:
M305 P1 B4388
-
For firmware versions 1.17 and later but lower than 3.0, use following command instead:
M305 P1 B4725 C7.060000e-8
-
For firmware versions 3.0 and later, use following command instead:
M308 P1 B4725 C7.060000e-8
-
Online Tool:
-
Click on the Calculate Thermistor Coefficients button in the Heaters tab, and select
Semitec 104-GT2 (used by E3D)
from the drop-down menu. -
with the most rewcent versions of the reprap firmware the following parameters shoudl be used:
-
-
-
Update your maximum temperature by sending the following G-Code command to your printer:
M143 S285
-
Online Editing:
-
Update your maximum temperature by going to the heaters tab and changing the option to
285
.
-
-
Head back to the V6 Assembly page to finish the last few steps before you start printing.
Head back to the V6 Assembly page to finish the last few steps before you start printing.
Cancel: I did not complete this guide.
One other person completed this guide.