Skip to main content
  1. In your slicer of preference find the retraction settings. In Slic3r  this is in printer settings. Start with a retraction length of 1mm If you experience blobs or stringing on the surface of the print increase the retraction length to 2mm.
    • In your slicer of preference find the retraction settings. In Slic3r this is in printer settings.

    • Start with a retraction length of 1mm

    • If you experience blobs or stringing on the surface of the print increase the retraction length to 2mm.

    • Do not increase the retraction length more than 2mm as this can lead to molten plastic being pulled into the heat break, increasing the likelihood of jams.

  2. An example of a retraction setting calibration print.
Finish Line

Dan Rock

Member since: 06/07/2018

21,496 Reputation

40 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 5

All Time: 91