-
-
First things first: you're going to need a copy of RepRap Firmware.
-
Either download a fresh version from GitHub, or edit your existing one.
-
You can edit your existing firmware either through the online configuration tool, or through G-Code.
-
-
-
Manual Editing:
-
In the web interface, go to the Settings/System Editor page and click on the config.g file to open it
-
For firmware versions 1.16 and earlier, change the M305 P1 line to the following:
M305 P1 T100000 B4388
-
For firmware versions 1.17 and later, change the M305 P1 line to this instead:
M305 P1 T100000 B4725 C7.06e-8
-
Online Configuration Tool:
-
If you have previously saved a .json configuration file for your printer, select "Use existing configuration" and browse to your .json file. If not, you will need to enter the parameters for your printer on each screen.
-
On the Heaters page, click on the Calculate Thermistor Coefficients button in the Heaters tab, and select
Semitec 104-GT2 (used by E3D)
from the drop-down menu.
-
-
-
Update your maximum temperature by sending the following G-Code command to your printer: M143 S245
-
Online Editing:
-
Update your maximum temperature by going to the heaters tab and changing the option to
245
.
-
-
Head back to the Lite6 Assembly page to finish the last few steps before you start printing.
Head back to the Lite6 Assembly page to finish the last few steps before you start printing.