Tools
No tools specified.
-
-
Gather the nozzle, heater block and heat break:
-
Nozzle
-
Heater Block
-
Heat Break
-
-
-
You should be looking at the side of the heater block with three holes in it
-
-
-
Screw in the nozzle all the way into the heater block. Don't worry about tightness yet.
-
Then, unscrew the nozzle by a 1/4 of a turn. This will leave a little space to tighten after screwing in the heat break.
-
-
-
Screw in the heat break until it touches the nozzle.
-
Tighten the nozzle against the heat break. No need to over tighten, we'll be hot-tightening later.
-
-
-
If there is significant space between the nozzle top and the heater block you should re-adjust your nozzle and heat break to eliminate that space.
-
Cancel: I did not complete this guide.
One other person completed this guide.