Skip to main content
  1. Gather the required Pats. You may choose to fit the bed at at a later stage as the bed must be removed again during the Wiring Installation.
    • Gather the required Pats.

    • You may choose to fit the bed at at a later stage as the bed must be removed again during the Wiring Installation.

  2. Place a washer onto each of the four M3 12mm Button Head Screws. Apply Thread Lock to one of the screws. Pass one of the screws into the corner of the bed plate from the underside.
    • Place a washer onto each of the four M3 12mm Button Head Screws.

    • Apply Thread Lock to one of the screws.

    • Pass one of the screws into the corner of the bed plate from the underside.

  3. Screw on a standoff. Do not sully tighten the screws. Repeat for each corner, remembering to apply Thread Lock as in the previous step.
    • Screw on a standoff.

    • Do not sully tighten the screws.

    • Repeat for each corner, remembering to apply Thread Lock as in the previous step.

    • Place the bed on top of the four standoffs.

  4. Slide a washer onto a standoff. Slide a washer onto a standoff. Slide a washer onto a standoff.
    • Slide a washer onto a standoff.

  5. Into each corner fit a Screw and washer. Tighten down the bed. Do not over tighten the screws, the bed must be able to expand during heating.
    • Into each corner fit a Screw and washer.

    • Tighten down the bed.

    • Do not over tighten the screws, the bed must be able to expand during heating.

Finish Line

6 other people completed this guide.

Greg Holloway

Member since: 11/27/2018

3,744 Reputation

8 Guides authored

2 Comments

What screws to be used in Step 5?

Tobias Müller - Reply

Scattering the instructions for the ht hbp across multiple guides is not a good idea. It should all be one place both bed install as well as wiring.

Andy Cohen - Reply

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 28

Past 30 Days: 130

All Time: 378