Skip to main content
  1. Gather:
    • Gather:

    • x1 Hemera assembly

    • x1 Hemera bowdaptor

    • x1 PTFE tube

  2. Screw in the Hemera Bowdaptor Screw in the Hemera Bowdaptor
    • Screw in the Hemera Bowdaptor

  3. Remove the Bowden clip Insert PTFE tube Insert collet clip
    • Remove the Bowden clip

    • Insert PTFE tube

    • Insert collet clip

    • Ensure the PTFE is pushed as far as it will go

  4. To adjust the idler tension, rotate the thumbscrew at the top. Rotating clockwise (with the heat sink engraving facing you) increases filament tension. Rotating anticlockwise decreases filament tension.
    • To adjust the idler tension, rotate the thumbscrew at the top.

    • Rotating clockwise (with the heat sink engraving facing you) increases filament tension.

    • Rotating anticlockwise decreases filament tension.

  5. Recommended starting idler lever tension.
    • Recommended starting idler lever tension.

    • The white spring block should be flush with the front face of the idler lever.

    • Further adjustment may be required dependant on material being used, for example flexible filaments may require additional tension.

Finish Line

Dan Rock

Member since: 06/07/2018

21,493 Reputation

40 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 3

Past 7 Days: 14

Past 30 Days: 102

All Time: 1,640