Skip to main content
    • Download the Marlin firmware Source files for your specific printer.

  1. Look for the Marlin.ino file inside the folder.
    • Look for the Marlin.ino file inside the folder.

    • Check to make sure you have selected the correct board.

    • You made need to contact your printer manufacturer if you are unsure.

  2. Select the configuration.h tab.
    • Select the configuration.h tab.

  3. Scroll down to the movement settings. You will need to change the esteps per mm value from X to 409.
    • Scroll down to the movement settings.

    • You will need to change the esteps per mm value from X to 409.

    • You can further calibrate the esteps per mm later if need be.

    • This figure is based on a x16 microstepping value.

    • You can now select upload to load the modified firmware.

Finish Line

Dan Rock

Member since: 06/07/2018

21,478 Reputation

40 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 10

Past 30 Days: 50

All Time: 685