Skip to main content

Is there a tried and tested firmware compilation for Anycubic Delta?

I have tried to run the Cyclops firmware on your guide but it does not have the config.h settings supplied by Anycubic to set up the kinematics for the Kossel Delta Plus.

Whenever I download the Marlin and Arduino files I do not get Marlin.ino in the files list, just Marlin.

It opens without the settings I have been using for the past year or so on the Anycubic firmware version.

Can someone PLEASE point me in the right direction to combine the dual extruders capacity with the normal Delta kinematics. I have been trying to solve this clash for countless hours without any real progress.

Thanks very much for any suggestions,

James.

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hi James,

Unfortuantly We do not have any example Marlin firmware configuration available, we typically recommend either contacting your printer manufacturer for the source files required to make modifications, or to start with a fresh install of marlin, which can be fairly tedious especially If you are not familiar with the required parameters.

Often I have found that there are user made pre-configured marlin versions of many popular 3D printers that can be found and used as a base for your modifications.

Was this answer helpful?

Score 0
Add a comment

Add your answer

James will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 35