Skip to main content

Our flagship jack-of-all trades all-metal HotEnd. V6 is suitable for practically any printer, and has the widest array of upgrade options. For everyday printing or exotic circumstances, V6 will deliver the reliability and performance that are E3D's specialities

18 Questions View all

Length of PTFE tube inside the hotend

When fully inserted (for a Bowden setup), how far in does the PTFE tube go in order to be fully seated?

Answered! View the answer I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Chosen Solution

For the 1.75mm V6, the PTFE tube needs to go 32.1mm into the heat sink, which also takes it into the very top section of the heat break. This is the same for Direct and Bowden set-ups. In the 3mm Bowden, the PTFE will insert by 9mm.

Was this answer helpful?

Score 1
Add a comment

Add your answer

Ray Price will be eternally grateful.
View Statistics:

Past 24 Hours: 1

Past 7 Days: 11

Past 30 Days: 71

All Time: 1,531