Skip to main content

extruder cog rocking back and forth

Hi, been trying to sort this issue for couple of days researching the internet etc. when ever my extruder tries to move it basically rocks back and forth and doesn’t pull the filament through. on occasions it doesn’t even respond.

i’ve checked all bolts they are just nipped up no over tightening of anything. i’ve tried turning the retraction right down an also up to 6mm just to see if it worked.

tried it with filament and with out.

made sure the cog isn’t catching on the mount

changed the connection cable

been through the firmware and can’t see anything out of place.

i have an creality ender5 pro and a titan aero fitted currently using 1.75mm pla.

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hi Mike,

Sorry to hear you are having issues with your Titan Aero, for troubleshooting advice please contact support@e3d-online.com.

Was this answer helpful?

Score 0
Add a comment

Add your answer

mike knox will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 3

All Time: 9