Skip to main content

Are there any official assembly guides for Prusa mk3s&mmu2s?

I am a user of mk3s.

Once the hemera has been installed, it will operate normally.

But I can't output because the filament stop position is different when I connect mmu2s.

The filament does not reach the drive gear.

What should I do? 

One more question is, what other settings do I need in the Prusa Slicer?

(ex : cooling tube position,cooling tube lenght,filament parking position,extra loading distance…)

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hi Tony,

Unfortunately, we have not tested the Hemera with the MMU so I cannot provide any firmware advice I’m afraid.

Was this answer helpful?

Score 0
Add a comment

Add your answer

tony kangsung will be eternally grateful.
View Statistics:

Past 24 Hours: 1

Past 7 Days: 3

Past 30 Days: 11

All Time: 11