Skip to main content

12v V6 cr10s heating issues

hello i just got in the e3d v6 12v. i have a cr10s when i turn on the power the heater starts to heat up by its self untell i turn the machine off not sure what happens if i leave machine on rather not find out ;)

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

2 Answers

Hi Douglass,

You have wired something up incorrectly, do not attempt to print and do not power on again until you have fixed the wiring.

Was this answer helpful?

Score 0

Comments:

only thing i have wired atm is the heater and the thermistor!

(i have updated the firmware)

I placed the heater cartridge where hotend two would go it did not heat up by its self.

maybe firmware issue or heater 1 has gone bad on motherboard.

any other ideas thank you for a quick response.

by

Add a comment

what happen it put 5 vdc to 12 vdc fan? the flow will be lower if put 12 vdc? I make a question because I buyed 12 vdc V6 and my printer is 24 vdc and only can get 5 vdc. thanks

Was this answer helpful?

Score 0
Add a comment

Add your answer

Douglas w Paul Jr will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 20