Skip to main content

New Install Clicking during extrusion

New install of Hemera, actually all my product from Filastruder was labeled as Hermes.

Anyways, when I bring the hot end to temp (225) and instruct to extrude 100mm, the extruder clicks and the lever moves back and forth, and there seems to be movement between stepper and the dual gear housing. I originally started with the tension set as stated in the manual, then tried lower tensions same issue. And the extruded PLA is VERY irregular. VREF is set to 1.194. Marlin 2.0x. I have a video if that would help.

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hi Bill,

If you can contact support@e3d-online.com we can help troubleshoot your issues further.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Bill McDaniel will be eternally grateful.
View Statistics:

Past 24 Hours: 1

Past 7 Days: 9

Past 30 Days: 27

All Time: 27