Skip to main content

Creality CR10S Pro v2

Hi, will the E3D v6 fit the Creality CR-10S Pro v2?

thank you

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

2 Answers

Most Helpful Answer

Hi Paul,

It won’t be a drop-in replacement, you will need to make modifications to the mount and firmware to use the V6 with your Creality CR10S Pro v2.

Was this answer helpful?

Score 1
Add a comment

many thanks to you Dan Rock.

I know about the Firmware alteration, but can the mount modifications be found on ‘thingiverse’? or the equivalent for printing? i’ve seen a CR10 mount ‘printable for this hot end would this fit?

Many thanks in advance

Was this answer helpful?

Score 0

Comments:

Thingiverse would be our suggestion for where to look. We haven't tested any of the mounts on there, however, so it would be up to you to determine whether any mounts you find would be suitable or not.

by

Add a comment

Add your answer

Paul will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 21

All Time: 43