Skip to main content

Hemera on Ender 5

Hello,

Can I get any firmware modification information on what I need to change for Hemera on Ender 5 Pro? I’m using the TH3D unified firmware U1.R2.A1.

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hi Jimmy,

I do not have any firmware instructions for your specific use case I’m afraid. What I can tell you are the steps you will need to change.

  1. Thermistor type, Hemera uses a 104 GT Thermistor.
  2. Temperature safety, Make sure thermal runaway is turned on and that your Min and Max values are correct, Min=5 Max=285(sometimes has to be 300 if there is a -15 LCD setting applied)
  3. Home offsets, if the nozzle sits in a different position to the previous extruder then you may well need to apply home offsets to make sure the bottom left-hand corner is the zero point.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Jimmy will be eternally grateful.
View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 19

All Time: 21