Skip to main content

My Aero extrudes so much plastic with the right steps

Hi there. When I extrude in the pronterface 100mm it consumes exactly 100mm of plastic. When I put it to print, it extrudes too much plastic. I get some acceptable results with a flow of 80% in slic3r. Any idea? The Plastic, PLA from Real filaments, is exactly 2.85.

Titan Aero | 2.85 | Full kit from e3d

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Strange, you might have the wrong diameter in your Slicer settings under 'filament settings'. I don't see how this could have been changed, but if it's below 2.85, then the Slicer will assume that value and accordingly increase the feed rate.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Magnus will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 40