Skip to main content

Firmware and files for Prusa Mk3s

Will you be releasing Guides and files for carriage for Prusa or we have to wait for them to do it?

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Most Helpful Answer

Hi Alex,

Yes, we will be releasing guides and files for the Prusa MK3, there isn’t currently a timeline on this, but it is being worked on.

Was this answer helpful?

Score 1

Comments:

Hi, - I followed the guide Prusa i3 MK3 Firmware Modifications on the Hemera firmware update for pinda probe offset, - but the printer crashes to the left side, and is unable to calibrate as it does not find the points on the bed., - is there some extruder offset x and y values that are missing from the guide ?

by

@marteinn Not that I'm aware of, the values shown in the firmware guide are the same as I used for the Prusa i3MK3 next to me. I have had issues where if the bed sheet wasn't seated evenly that sometimes the probe failed on the right-hand side, but never had the issue on the left.

by

Add a comment

Add your answer

Alex will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 8

All Time: 24