Skip to main content

Using a E3D V6 extruder with the Titan

Hi,

I currently have an original E3D v6 hotend which uses a the black collet to hold the Ptfe tube in place, while installing I realized that the black collet needs to be removed.

How do I get the golden ring shown in the guide to hold the ptfe tube ni place, without the black collet the tube tends to shake a bit inside and can make loading and unloading filament a bit painful.

Regards,

Hussain

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hi Hussain,

The brass ring is no longer part of the V6 heatsink, the heatsink was redesigned in order to have the geometry that holds the collet in place machined into the aluminium rather than requiring an insert in order to remove a step.

For more help troubleshooting your issue I would recommend contacting support@e3d-online.com

Was this answer helpful?

Score 0
Add a comment

Add your answer

Hussain will be eternally grateful.
View Statistics:

Past 24 Hours: 4

Past 7 Days: 10

Past 30 Days: 24

All Time: 24