Skip to main content

Thermistor & Fan Connectors

Hi Guys, I’m rebuilding an old Mankati Fullscale XT, but there are no connectors at the machine end. Rather than cut the nice plugs off the brand new V6 hotend I’ve just received, I’d rather fit the relevant male/female parts to the printer

I believe the type to be Molex, but size, part number so I can order the parts?

Can anyone help?

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hi Simon,

The Molex connectors used are Molex Microfit 3.0, the DuPont connectors used are just dual female DuPont connectors.

Was this answer helpful?

Score 0

Comments:

There are several part numbers associated with the Molex Microfit 3.0 line of connectors. I too have the same issue. Ordering the right one via the part number would be helpful. Or at least the part number of the male connector so a suitable female connector part number could be found.

by

Add a comment

Add your answer

Simon Jolley will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 15

All Time: 25