Skip to main content

Remove 4.7k pull up

Will removing the 4.7k pull-up from pin 13 on a controller allow one to keep using pin 13 with the PT100 amp?

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hi JLH,

That may well be a possibility but we cannot guarantee that it will work. I would always recommend speaking to the manufacturer of the printer baord directly in this regards.

Was this answer helpful?

Score 0
Add a comment

Add your answer

JLH will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 5

All Time: 18