Skip to main content

All motors available on our Website

6 Questions View all

Stepper Driver Settings for Motor?

Hello!

I recently bought a Titan extruder with the slimline motor. I have a RAMBo board with the digital trimpots. I haven't been able to find a section where it tells what suggested voltage I should use with this motor.

What would anyone suggest for the voltage? Thanks in advance!

- Avery

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

For the RAMBo you set the current in the configuration_adv.h file. You can set it to anywhere between 0 and 255. I'd suggest 255, which roughly equates to 1.4 A. You'll need this to power most of our motors.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Avery T will be eternally grateful.
View Statistics:

Past 24 Hours: 3

Past 7 Days: 4

Past 30 Days: 26

All Time: 999