Skip to main content

What is the type number of the thermistor (number to set in MARLIN) ca

since i change my hot end for a new 12volts volcano, i canot set my temp. at 200 degrees wanted, the display show 199? it is not stable!

What type number of sensor should be set for the thermistor?

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

3 Answers

The default thermistor in the kit, is number 5 in the thermistor tables for Marlin firmware.

Was this answer helpful?

Score 0
Add a comment

Ok, i havé anthère question:

I had problems to reach 200 degrees and rest at this temperature stable!!!

I mesured the resistor beetwin 2

wired of the volcano tip and it

was 10.2 ohms!

My original tip mesure 5 ohms for 12 vcc supply!

Us this normal 10,2 ohms at 12 vcc???

Was this answer helpful?

Score 0
Add a comment

A 12v 30w cartridge should have a resistance of 4.8 ohms. At 10.2, your heater cartridge is at 14w. Can you contact support@e3d-online.com, your heater cartridge as a fault.

Was this answer helpful?

Score 0
Add a comment

Add your answer

pierre will be eternally grateful.
View Statistics:

Past 24 Hours: 2

Past 7 Days: 5

Past 30 Days: 11

All Time: 150