Skip to main content

E3D's Kraken Hot End is the multi-nozzled, water-cooled, Bowden-fed, plastic-extruding monster! It uses standard V6 heater blocks and nozzles, which means that you can upgrade it with E3D's wide range of nozzle sizes and materials. Kraken is an experimental product, which means that we have a little less documentation and experience with using it. Nonetheless it is a fully-supported member of the E3D ecosystem that many customers have installed and used successfully.

1 Questions View all

Cr 10 s5 compatibility

Can i install it on my cr-10? If so how? I am using the cr-10 s5

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hi Nir,

The Kraken is an experimental hot end, we do not provide specific upgrade kits for our standard range of hot ends let along the Kraken.

The Kraken is intended for very experienced users who are willing to design custom mounts and who understand the nuances of firmware configuration.

If you are interested in dual extrusion printing I would recommend looking at either the Cyclops+ or the Chimera+

Was this answer helpful?

Score 0
Add a comment

Add your answer

Nir levy will be eternally grateful.
View Statistics:

Past 24 Hours: 1

Past 7 Days: 4

Past 30 Days: 14

All Time: 345