Everything you need to know about the Cyclops!

5 Questions View all

Cyclops won't drive extruder 2

I have installed a Cyclops extruder being driven by a MKS controller (V1.6) running Repitier firmware. I have configured the firmware and the host software as described. When I try to manually drive extruder 1 it works as expected but if I select extruder 2 in Repitier host and try to manually extrude, extruder 1 starts to run. I cannot get extruder 2 to drive.

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hi Phillip,

The best way for us to sort out this issue would be to contact support@e3d-online along with some images of the control board connections and a screenshot of the firmware configurations.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Philip Noon will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 7

All Time: 63