Skip to main content

Everything you need to know about the Cyclops!

6 Questions View all

Retraction for cyclops +

What is the recommended retraction settings for the cycops +?

Answered! View the answer I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Chosen Solution

Hi Patrick,

Ideally for the Cyclops+ you would use no retraction, if you do experience a lot of stringing then you can use a small value such as 0.2 - 0.5mm, however make sure you do not use retraction when changing filaments ie toolchange retractions as this can lead to jams. With the Cyclops+ you will ideally want to use a priming tower or ooze shield to switch colours, using a retraction to change the filament can cause the HotEnd to jam.

Was this answer helpful?

Score 1
Add a comment

Add your answer

Patrick Nusbaum will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 21

All Time: 382