Original post by: James ,
Is there a tried and tested firmware compilation for Anycubic Delta?
I have tried to run the Cyclops firmware on your guide but it does not have the config.h settings supplied by Anycubic to set up the kinematics for the Kossel Delta Plus. Whenever I download the Marlin and Arduino files I do not get Marlin.ino in the files list, just Marlin. It opens without the settings I have been using for the past year or so on the Anycubic firmware version. Can someone PLEASE point me in the right direction to combine the dual extruders capacity with the normal Delta kinematics. I have been trying to solve this clash for countless hours without any real progress. Thanks very much for any suggestions, James.
Cyclops Firmware Dual Extruders for Anycubic Delta Plus