Skip to main content
Help

Original post by: Jeremy Chavers ,

Title:

E3D Titan Extruder and PETG?

Text:

Struggling to get PPE to print using an E3D Titan extruder bowden setup and PETG. There’s one spot where there’s a lot of retractions, and the PETG is getting chewed up to the point where it stops feeding because it won’t fit into the bowden. I’ve tried Capricorn, cheap chinese, and factory bowden, and multiple different pressures on the tension adjustment for the Titan.

Any tips?

Category:


               
            
                     

Status:

open