Skip to main content
Help

Current version by: Dan Rock ,

Text:

Hi Aaron, [br]
 
 
[br]
 
 
Unfortunately we do not have specific connection guides for specific boards, I would suggest looking up some pin out diagrams for your specific board in order to ascertain the correct connection points. https://reprap.org/wiki/Ultimaker%27s_v1.5.7_PCB#Thermocouple_sensor_board
 
Other wise as long as your printer board follows the typical Arduino Mega architecture then you should follow the this PT100 connection guide, [[E3D PT100 Amplifier Documentation]] .
Other wise as long as your printer board follows the typical Arduino Mega architecture then you should follow the this PT100 connection guide, [[E3D PT100 Amplifier Documentation]] .
 
It may not be for the exact same board but the instructions should still be applicable.

Status:

open

Original post by: Dan Rock ,

Text:

Hi Aaron, [br]

[br]

Unfortunately we do not have specific connection guides for specific boards, I would suggest looking up some pin out diagrams for your specific board in order to ascertain the correct connection points. https://reprap.org/wiki/Ultimaker%27s_v1.5.7_PCB#Thermocouple_sensor_board

Other wise as long as your printer board follows the typical Arduino Mega architecture then you should follow the this PT100 connection guide, [[E3D PT100 Amplifier Documentation]] .

It may not be for the exact same board but the instructions should still be applicable.

Status:

open