Skip to main content
Help

Current version by: aaronV ,

Title:

PT100 Amp Board with Ultimaker 1.5.7 pcb wiring

Text:

Attempting to wire this up, it’s not working as I’ve got it (into the temp sensor 1 slot). Can someone please just tell me how this is supposed to be wired so I can stop effing around with it and get my printer running again???
 
=== Update (02/05/2019) In Response to Dan’s first answer- ===
 
Well, i’ve done all that and more in the past 11 days, and something is missing. I’m not sure if it’s missing from your instructions, though that’s my guess, or somewhere else. I currently have the PT100 installed in my hot end (A V6 gold with a copper-plated Volcano block, all from you guys, mind you), wired into the 2 pins on the amp board (I assume that which wire to which lead is immaterial), then the three pin is 5v to 5v, neutral to ground, signal directly to the Analog 3 pin on the Arduino. Firmware: been through about 20 times double checking and trying different stuff, different pins, etc. Tried 3 different user temp tables, one was the table from the previous thermistor that came with the V6, and should have worked according to your instructions, and twice (at least) with variations of the PT100 tables i’ve found. So, at this point, I think a little help from you guys to get your products up and working would be lovely.

Category:

Temperature sensors

Status:

open

Accepted Answer:

256

Edit by: aaronV ,

Title:

PT100 Amp Board with Ultimaker 1.5.7 pcb wiring

Text:

Attempting to wire this up, it’s not working as I’ve got it (into the temp sensor 1 slot). Can someone please just tell me how this is supposed to be wired so I can stop effing around with it and get my printer running again???
 
=== Update (02/05/2019) In Response to Dan’s first answer- ===
Well, i’ve done all that and more in the past 11 days, and something is missing. I’m not sure if it’s missing from your instructions, though that’s my guess, or somewhere else. I currently have the PT100 installed in my hot end (A V6 gold with a copper-plated Volcano block, all from you guys, mind you), wired into the 2 pins on the amp board (I assume that which wire to which lead is immaterial), then the three pin is 5v to 5v, neutral to ground, signal directly to the Analog 3 pin on the Arduino. Firmware: been through about 20 times double checking and trying different stuff, different pins, etc. Tried 3 different user temp tables, one was the table from the previous thermistor that came with the V6, and should have worked according to your instructions, and twice (at least) with variations of the PT100 tables i’ve found. So, at this point, I think a little help from you guys to get your products up and working would be lovely.

Category:

Temperature sensors

Status:

open

Original post by: aaronV ,

Title:

PT100 Amp Board with Ultimaker 1.5.7 pcb wiring

Text:

Attempting to wire this up, it’s not working as I’ve got it (into the temp sensor 1 slot).  Can someone please just tell me how this is supposed to be wired so I can stop effing around with it and get my printer running again???

Category:

Temperature sensors

Status:

open